Lessons on this page
1Check if an X-ray is calibrated
- Open the X-ray in the viewer.
- Look at the small text at the bottom left of the picture.
- "Not calibrated — measurements in pixels" means lengths are NOT in mm yet.
- "Calibrated · 14.8 µm/px" means lengths show in mm.
- For more detail, open the Adjust tab and read Calibration. It says if the value came from DICOM file, from sensor settings or was set manually.
Tip: Some images are calibrated by themselves: a DICOM file that carries its pixel size, or an image from a sensor whose Sensor pixel size (µm) was typed in Devices.
Note: Pixels are not millimetres. Never read a px number as mm. Calibrate first.
2Calibrate an X-ray with a known length
- Find something in the picture whose real length you know, for example an endo file or an implant.
- On the left strip, click the cross-hair tool Calibrate with a known length.
- Press on one end of that object, drag to the other end and let go.
- The pop-up Calibrate measurements opens and shows how many px your line is.
- Type the true length in Real length (mm), for example 21.
- Click Apply.
- The bottom-left text now says Calibrated, and all measurements on this image show in mm.
Tip: Zoom in before you draw the line. A careful line gives a better result.
Note: Calibration is for this one image only. Even after calibrating, an X-ray is a shadow picture: the angle of the sensor stretches or shortens things. The viewer itself says "Radiographic measurements include projection error. Verify clinically."
You drew a line of 412.6 px. Enter its real length — for example a known file length or implant length.
3Measure a straight length
- Make sure the image is calibrated if you need mm.
- On the left strip, click the ruler tool Distance.
- If you like, choose a label in the bar above: Plain measurement, Working length, Bone level, Canal or Implant.
- Press on the start point, drag to the end point and let go.
- The length shows beside the line.
Tip: Keyboard: press D for the Distance tool.
Note: On an image that is not calibrated the number is in px, not mm.
4Measure a curved canal, an angle or an area
- For a curved canal: click Curved length (canal). Click point after point along the canal. Double-click (or press Enter) at the end. The total length shows.
- For an angle: click Angle (3 clicks). Click the first arm end, then the corner, then the second arm end. The angle shows in degrees.
- For an area: click Area / perimeter. Click around the outline of the area. Double-click (or press Enter) to close it. The area and the perimeter show.
- Press Esc if you want to cancel a measurement you started.
Tip: Keyboard: press A for the Angle tool. Angles do not need calibration. Lengths and areas do.
Note: Area shows in mm² and length in mm only on a calibrated image. Otherwise they are in pixels.
5Copy the measurements into the notes
- After measuring, click the Clinical tab on the right.
- Scroll under the Notes box.
- Click the link Add 2 measurements to notes (the number matches how many you made).
- The values are written into Notes as a small list.
Note: If the image is not calibrated, the list is headed "Measurements (uncalibrated, px):" so nobody reads it as mm.
6Remove a calibration
- Open the X-ray and click the Adjust tab.
- Under Calibration, click Remove.
- Click OK on the question "Remove calibration? Measurements will show in pixels."
- Calibrate again with the cross-hair tool if needed.
Did this not solve it? Message our support team and we will help you.
